The following common sense should be mastered in the safe operation of the bottle blowing machine:

(1) Before starting each shift, you can add lubricating oil to each moving part, including the manipulator, the manipulator guide, and the opening and closing mold guide.

(2) The swing arm can be added for one (3-4) day. The large and small chains of the heater can be used once a month. Always check whether the engine reducer and heater reducer are short of oil. The main bearing can be added every three months.

(3) Check whether the moving parts are firm, whether the screws are loose and fall off, especially in the case of large impact, whether the belt drive parts are abnormal.

(4) Check whether the high-pressure air source, low-pressure air source, power supply and water source are normal.

(5) Check the emergency stop switch, safety door switch and protection device, and check whether the switch is normal.

(6) Check whether the heating head enters the embryo and whether the embryo drop part is working normally. If the insertion is not in place, an adjustable embryo press device nut can be used.

(7) Check whether the lamp tube is damaged or damaged. Timely changes.

(8) Check whether the pneumatic components are leaking and whether the action is sensitive.

(9) Check whether the triplet leaks abnormally, whether it is blocked, and whether the water cup is too full.

(10) When the solenoid valve of the automatic bottle blowing machine is abnormal, it should be cleaned in time.