The product is teaching you how to extend the life of the bottle blowing machine, which is also a concern for bottle blowing machine users. Generally speaking, when using a bottle blowing machine, operate according to its safety operation specifications. The correct use of the bottle blowing machine will minimize the damage to the bottle blowing machine. What are the safety operation specifications for the bottle blowing machine?

1. Before starting up each shift, lubricating oil must be added to each moving part once. (Manipulator, manipulator guide rail, mold opening and closing guide rail)

2. The swing arm can be added once (3-4) days. The large chain and small chain of the heating machine can be used once a month. Frequently check whether the main engine reducer and the heating engine reducer are short of oil. Host bearings can be (2-3) months plus once.

3. Before production, check whether the moving parts are firm, whether the screws are loose and fall off, especially where the impact is strong, whether the belt drive part is abnormal.

4. Check whether the high-pressure gas source, low-pressure gas source, power supply and water source are normal.

5, check the emergency stop switch, safety door switch, protection device detection switch is normal.

6. Check whether the heating head enters the embryo and the embryo dropping part works normally. If the blastoff is not in place, the nut of the blastoff device can be adjusted.

7. Check whether the lamp tube is damaged or broken. to be replaced in a timely manner.

8. Check whether the pneumatic components are leaking and whether the action is sensitive.

9. Check whether the triplet leaks abnormally, is blocked, and whether the water cup is too full.

10. When the solenoid valve of the bottle blowing machine is abnormal, it should be cleaned in time (cleaning once every bottle blowing 3.5 million).

11. The bottle blowing mold must be cleaned and polished regularly.

12. When opening the high and low pressure air source switch, it must act slowly to prevent the air source from blowing dirt into the solenoid valve too fast, and at the same time open the exhaust valve for 30 seconds to ensure that the air is clean.